Rubber gasket that seals the BBSHD controller to the motor. It sits between the controller and the motor housing and keeps water and dirt away from the wiring behind the controller.
BBSHD only. Will not work with the BBS02 or BBS01.
When to replace it. Any time the controller comes off, and any time the old one is torn, flattened or has gone hard. A gasket that has been squeezed once may not seal a second time.
How to change it. Disconnect the battery and remove the three controller bolts with a 3 mm hex key. Ease the controller back and unplug the motor wires, which run through the middle of the gasket. Fit the new gasket with its three ears over the bolt holes, plug the wires back in and tighten the bolts evenly.

One gasket per order. Bolts not included.
Other BBSHD gaskets: motor core gasket and gear case gasket. Replacing the controller too? See the BBSHD replacement controller.