The best viscosity ferrofluid for hub motor cooling
Proven to dramatically cool down your direct drive hub motor
Increases power, range, efficiency, and longevity
Run more power through your motor without overheating
5 ml of Ferrofluid injected into a direct drive hub motor will effectively make your direct drive hub motor more efficient by making it run cooler.
The syringe will fit in holes as small as 2mm so that you can drill a small hole in your hub motor so you can ferro cool it without even taking it apart.
The magnets inside your motor will ensure that the ferrofluid does not leak out of the hole you drilled ( a big problem with oil cooling hub motors which also works for cooling but can make messy)
This is the highest grade ferrofluid available and will last for years even in the most rugged riding conditions. The drawback to cheaper lower quality ferrofluid is they will have drastically lower life span. Ferro Tec APG 1110 has been proven to last in rugged riding conditions for a year or longer. We recommend that you add more ferrolfuid to your hub motor every 2 years to ensure maximum cooling efficiency.
Ferrofluid is the snake oil that really does get more power out of your direct drive motor for very little investment and just a bit of work.
This is really a big breakthrough in hub motor technology that has come about in the last year.
Get the best Ferrofluid available Ferro Tec AGG 1110 for a great price.
You can take apart your hub motor to apply, or more conveniently just drill a hole as small as 2mm and squirt inside.
5ml of fluid is enough for most hub motor, use 7ml if you are running a 3000w hub motor or larger.
Ferrofluid is as magnetic fluid that bonds to the stators of your direct drive motor which helps dissipate heat by transferring heat to the motor cover and make your motor run cooler.
This is the scientific grade name brand ferrofluid made by Ferro Tec.
Once your hub motor runs cooler it means its more efficient and more reliable, which means you can run more amps which means more power. This Ferrofluid does NOT make your DD motor more powerful, it only allows you to run more amps through the motor before it overheats and causes damage to the coils, hall sensors or phase wires.
People have been putting oil in their hub motors for years to increase cooling, since ferrofluid is magnetic it bonds to the stator, not only doing a better job of cooling the stator, but also will not leak out of the motor onto your nice carpeted floor (if you park your ebike inside)
Makes good sense in theory. I'm sure it's better than drilling holes in your Hub motor at the very least. I figure the thick 10ga spokes will act as heat sinks and will not be bolting on the weird fins.